以太网芯片大搜索

stevenchen

资料索取及样片申请联系：
Steven(陈先生)
MOB：13823576010
MSN：zhongxinchen@126.com
E-MAIL：steven.chen@kada.com.cn


Fast Ethernet switch with Processor
Interface
DM9013E  (128-pin/LQFP, MP Now)
● With 3 Ports, 10/100Mbps Switch Controller
● With two 10/100Mbps DSP PHY, one MII,
● Built in 32-bit Processor Interface
● Support 802.1P, 802.1Q VLAN, QoS.
● Support TCP/UDP/IPv4 checksum offload
● Support HP Auto-MDIX
● 1.8V internal core, 3.3V I/O with 5V tolerant

DM9003E  (64-pin/LQFP, MP Now)
● With 2 Ports, 10/100Mbps Switch Controller
● With two 10/100Mbps DSP PHY
● Built in 16-bit Processor Interface
● Support 802.1P, 802.1Q VLAN, QoS.
● Support TCP/UDP/IPv4 checksum offload
● Support HP Auto-MDIX
● 1.8V internal core, 3.3V I/O with 5V tolerant

DM9103E  (128-pin/LQFP, MP Now)
● With 3 Ports, 10/100Mbps Switch Controller
● With two 10/100Mbps DSP PHY, one MII,
● PCI Interface
● Support 802.1P, 802.1Q VLAN, QoS.
● Support TCP/UDP/IPv4 checksum offload
● Support HP Auto-MDIX
● 1.8V internal core, 3.3V I/O with 5V tolerant

Ethernet Local-Bus Single Chip
DM9000AE  (48-pin / LQFP,0 .25um )
●  10/100Mbs w/Auto-MDIX
●  3.3V with 5V tolerant I/O, 6 GPIO Pins
●  Local-Bus / uP interface (byte/word), 4K Dword SRAM
●  Support back pressure for duplex mode fl0 ow control
●  Support TCP/IP checksum offloadz
●  Supports Early Tx

DM9000E  (100-pin / LQFP, .35um MP Now)
●  10/100Mbs Local-Bus Interface for embedded applications, 3.3V with 5V tolerant I/O, 4 GPIO Pins
●  Local-Bus / uP interface (byte/word/Dword), 4K Dword SRAM, MII/reverse MII interface
●  Support back pressure for duplex mode flow control

PCI Fast Ethernet Single Chip MAC/PHY
DM9102D (128-pin / QFP & LQFP,MP Now)
●  10/100Mbs 2.5/3.3V with 5V tolerant I/O, 0.25um CMOS process
●  Supports Auto-MDIX, external MII interface, Wake-On-LAN & QoS
●  Comply with PCI specification 2.2, IEEE 802.3u 100Base-TX, 802.3 10Base-T, ACPI and Bus Power Management

DM9010AE (100-pin / LQFP, 0.25um )
●  10/100Mbs w/Auto-MDIX
●  3.3V with 5V tolerant I/O, up to 23 GPIO pins
●  Local-Bus / uP interface (byte/word/Dword), 4K Dword SRAM, MII/reverse MII interface
●  Support back pressure for duplex mode flow control
●  Support TCP/IP checksum offload
●  Supports Early Tx

DM9008AE (48-pin/LQFP, MP Now)
● 10Mbps w/HP Auto-MDIX
● Local-Bus / uP interface (byte/word)
● Support TCP/IP checksum offload & Early Transmit
● Built in 3.3V to 2.5V Regulator
● 3.3V with 5V tolerant I/O, 6 GPIO Pins

Ethernet Switch / Hub/Media Controller
DM8606AF (128-pin QFP, MP Now)
●  1.8V/3.3V with 3.3V tolerant I/O, 12Kx64 SRAM
●  Support  5 Ports 10/100Mb Auto-MDIX switch ports with TX/FX interfaces and one MII/GPSI port
●  Support 2048 MAC address table
●  For multi-port bundle sale with DM9000E Series

DM8203E (64-pin/LQFP, MP Now)
● 1.8V internal core, 3.3V I/O with 5V tolerant
● Support 2 Ports 10/100Mb HP Auto-MDIX Switch ports with TX/FX interfaces and one MII port
● Support Bandwidth control & four queue for QoS

Fast Ethernet Single PHY ceiver
DM9161AE (48-pin / LQFP,MP Now)
●  10/100Mbs 3.3V with 5V tolerant I/O, 0.25um CMOS process
●  Support MII/RMII (Reduced MII)/GPSI (7-Wired) interfaces
●  Support Auto-MDIX

Modem / MFP SoC Chipset
DM562AP (w/DM6588A:128-pin/QFP, w/DM6580:
48-pin/LQFP, MP Now)
● 2.5V/3.3V with 5V tolerant I/O.
● Support MFP G3 33.6K color Fax engine with T.31
command
● Support synchronous mode, POS and CID

DM562PM (H/W based Module-Kit, MP Now)
● Support Module-Kit to interface ISA/RS232//PCI/IR/ for
Embedded system.

DM6288F (ES Q1/07)
● 2.5V/3.3V with 5V tolerant I/O
● Cost-effective system solution for embedded Fax
product application, with MFP Fax protocol driver.


[em01][em01]