3G NSFT fail

wangreborn

WCDMA NSFT fail

各位大师有没有知道情况的？

==================== WCDMA NSFT begin =====================

------------------------------------------------------------
AG8960 < Trigger Arm to be Single
AG8960 < TFCI Pattern (1)
AG8960 < UL Scrambling code (0)
AG8960 < DPCH Channel code (OVSF) (9)
AG8960 < DPCH BcBd Control to Auto
AG8960 < Loopback type to be type1
AG8960 < DTCH DATA to be All Zeros
AG8960 < BER Test Bits 10000
AG8960 < Config ILPC Measurement
--- Test Case_1 --- start
AG8960 < RFG off
AG8960 < UARFCN UL = 9612
AG8960 < UARFCN DL = 10562
Get Corresponding band for DL channel(10562) ->BAND1
AG8960 < Config input cable loss (-1.00)
AG8960 < Config output cable loss (-1.00)
AG8960 < Cell Power -75.00
AG8960 < set CPICH Level to -10.0
AG8960 < set PICH Level to -15.0
AG8960 < set CCPCH Level to -12.0
AG8960 < set DPCH Level to -10.3
AG8960 < Analyzer Max Level 24.00
AG8960 < RFG on
META_3Grf_NSFT_StartEx_r Retry 1 time(s).
META_3Grf_NSFT_Start_r PASS.
target < NSFT start
======= [1] CHAN UL: 9612, DL:10562 =======
AG8960 < wanted MS target power = -50.00 dBm
AG8960 < UL CL Power Control to be WCDMA_UL_CL_PWR_MODE_DOWN, Algo1, StepSize(1dB)
AG8960 < Initiate Measurement for NSFT TPC
FAIL : AG8960 < Query Initiate State
FAIL: AG8960 < NSFT min power measurement
FAIL : Measure NSFT TPC fail.


        WCDMA NSFT Total time = 9.52(sec)


        WCDMA NSFT cost time = 9.56(sec)


##


Calibration and SFT total cost time is: 317.55s

hej

非信令。。。