ADS PCB仿真

liuchao240

我用ADS 仿了一个功分器，在ADS原理图导入到PCB后，隔离电阻没作用了，Momentum RF仿真出来的S11 S21 S31 还行 但S22 S33 S23 都差得离谱，初步分析是隔离电阻没有参与计算，请问高手器件怎么和PCB同时在Momentum RF里面仿真？

第二个问题
我将Momentum RF仿真后的数据，再导入到原理图进行仿真，为什么没有看到ref的参考点，只有几个端口？


谢谢！

wsxjjwps

要用原理图版图联合仿真吧。。。。。先把PCB生成原件。。。再回到原理图取出PCB原件再加电阻

liuchao240

自己顶下

liuchao240

这个错误又怎么解决[/COLOR]
Simulation / Synthesis Messages

Warning detected by hpeesofsim during SP analysis `SP1'.
    The simulation temperature (25.0 C) is not the same as the IEEE standard
    noise temperature (290 K or 16.85 C) in the noise analysis `SP1'.
    If the simulation temperature is not equal to the IEEE standard temperature,
    then the loss and the noise figure will not agree for a passive circuit.
    The `Temp' parameter on the Options item can be set to 16.85 C to
    eliminate this warning message.

Status / Summary


hpeesofsim (*) 2008.500 Jan 22 2008 (built: 01/22/08 22:02:45)
Copyright Agilent Technologies, 1989-2008.

SP SP1[1] <E:\ATF54143_prj\networks\LNA_total>   freq=(500 MHz->3 GHz)

liuchao240

期待[em06][em06]

liuchao240

以下是引用wsxjjwps在2012-5-19 16:51:17的发言：
要用原理图版图联合仿真吧。。。。。先把PCB生成原件。。。再回到原理图取出PCB原件再加电阻

联合仿真报错，请教下怎么解决,谢谢！

******************************************
***** Abnormal Simulator Termination *****
******************************************
The simulator has unexpectedly terminated.



Simulation / Synthesis Messages

Warning detected by hpeesofsim during SP analysis `SP1'.
    The simulation temperature (25.0 C) is not the same as the IEEE standard
    noise temperature (290 K or 16.85 C) in the noise analysis `SP1'.
    If the simulation temperature is not equal to the IEEE standard temperature,
    then the loss and the noise figure will not agree for a passive circuit.
    The `Temp' parameter on the Options item can be set to 16.85 C to
    eliminate this warning message.

Status / Summary


hpeesofsim (*) 2008.500 Jan 22 2008 (built: 01/22/08 22:02:45)
Copyright Agilent Technologies, 1989-2008.

SP SP1[1] <E:\ATF54143_prj\networks\LNA_total>   freq=(1 GHz->4 GHz)
Warning detected by hpeesofsim during SP analysis 'SP1'.
    `LNA_PORT_1':   The model for the Layout Component is reused from the ModelDatabase.
,,,,,,,,,,,,
,,,,,,,,,