wcdma 通话电流设置

piao123

Parameters        Value        Comment
Serving Cell UARFCN (downlink)        Band I: Mid Range
Band II: Mid Range
Band III: Mid Range
Band IV: Mid Range
Band V: Mid Range
Band VI: Mid Range
Band VII: Mid Range
Band VIII: Mid Range
Band IX: Mid Range        All bands supported by the handset must be measured.
Results must indicate which band(s) have been measured, and individual result for each band

Serving Cell UARFCN (uplink)       
Band I: Mid Range
Band II; Mid Range
Band III: Mid Range
Band IV: Mid Range
Band V: Mid Range
Band VI: Mid Range
Band VII: Mid Range
Band VIII: Mid Range
Band IX: Mid Range       
Serving Cell Scrambling Code        255       
Use secondary scrambling code        No       
Fixed Channelisation code        Yes       
Hard Handover        No       
Soft / Softer Handover        No       
Channel type – UL & DL / Bearer        Voice 12.2k (AMR)
"Conversational / speech / UL:12.2 DL:12.2 kbps / CS RAB + UL:3.4 DL:3.4 kbps SRBs for DCCH" (as defined in 3GPP TS25.993-6.7.0 Ref #4)       
CPICH_RSCP (Ec)        -97 dBm        This level is typically seen on network serving cells
Serving cell code power (DPCH_Ec/Ior)        -5dB        This level is measured as an offset from channel power
Ec/No        > 12 dBm        Used value shall be reported with the test results
Uplink DTX        No       
Handset Tx level        1) Fixed value of 10 dBm
AND
2) Power distribution as defined below

piao123

自己顶一下[em01]