教你手动测试EMC,Part 5 – Conducted Immunity

lighterx

【文件名】:08122@52RD_EMCTestingPart5.pdf
【格　式】:pdf
【大　小】:838K
【简　介】:
【目　录】:




Table of contents for this Part

5 Conducted RF immunity
5.1 Non-CE issues with immunity testing
5.2 Introduction to conducted immunity testing
5.2.1 Injecting a reasonably accurate RF voltage (or current)
5.2.2 Preventing leakage
5.2.3 The non-linear sensitivity of analogue and digital semiconductors to RF.
5.2.4 Determining an ‘engineering margin’
5.2.5 Monitoring the EUT to be able to tell when its performance has degraded too much.
5.3 Alternative transducers and test methods
5.3.1 [unnecessary repetition] Close-field probes
5.3.2 Voltage injection probe
5.3.3 ‘Crosstalk’ injection techniques
5.3.4 Licensed radio transmitters
5.3.5 Bulk Current Injection (BCI)
5.3.6 Direct injection with a CDN
5.3.7 The ‘EM Clamp’
5.3.8 General notes on test set-ups
5.4 Signal generators and power amplifiers
5.4.1 Alternative types of signal generator
5.4.2 RF Power Amplifiers
5.5 Correlating alternative test methods with EN 61000-4-6
5.6 On-site testing
5.7 Full compliance conducted RF immunity testing
5.7.1 Generator
5.7.2 Transducers
5.7.3 Calibration and levels
5.7.4 Test setup 5.8 References

ngwingyan

謝謝分享

342433336

如何下载？