找回密码
 注册
搜索
查看: 11995|回复: 15

[讨论] diplexer 和 duplexer 有区别吗? 内有diplexer原理图,谁能画出duplexer的原理图?

[复制链接]
发表于 2010-10-30 20:15:03 | 显示全部楼层 |阅读模式
英文是找到的对diplexer和duplexer的区别介绍。
What's a diplexer? It's a three-port network that splits incoming signals from a common port into two paths (sometimes called "channels"), dependent on frequency. A diplexer is the simplest form of a multiplexer, which can split signals from one common port into many different paths. The incoming signals must be offset in frequency by an appreciable percentage so that filters can do their job sorting them out.

A diplexer could be used to route signals to two different receivers, based on frequency. Or it could be used to create a "matched" filter that is non-reflective outside of the intended passband. It could also be used as a bias tee, to feed your favorite active device with DC power.

Don't confuse the word diplexer with duplexer, which is the three-port network that permits a transmitter and receiver to use the same antenna, at essentially the same frequency. Duplexers are often used in radar, because the transmitter and receiver commonly share an antenna, and the returned signal doesn't vary much from the transmitted signal in frequency (just shifted slightly by the Doppler effect).

Important properties of a duplexer are:

Low loss between transmitter and antenna in transmit (less than 1 dB is desirable)
High isolation from transmitter to receive in transmit (as much as 80 dB for megawatt systems)
Low loss between antenna and receiver in receive (less than 1 dB is desirable)
Fast switching between the transmit and receive state, sometimes "automatically switched by the transmit signal, sometimes by command signal.

可见,diplexer的原理很明显,如图所示,
但是据英文所讲duplexer的重要特点,很像一个TR开关或者环形器。
但是这么高的隔离度环形器或者开关又不太好做到吧,对于大功率的开关的开关速度可能也无法满足。
有高手能解释下吗?最好能画个原理图出来,谢谢啦!
发表于 2010-11-1 11:24:41 | 显示全部楼层
dip是双讯器、dup是双工器
点评回复

使用道具 举报

发表于 2010-10-31 21:39:56 | 显示全部楼层
diplexer 的定义,第一段已经说的比较清楚了,中文叫分频器,内部由一个高通滤波器和一个低通滤波器构成,一个负责通过高频TRX,另一个通过低频TRX,两者频段差异比较大;双工器内部由两个频段不同的带通滤波器构成,一个负责TX,另一个负责RX。手机里主要用到LC的分频器和声表的双工器。LC的分频器多见于分离CDMA800/1900信号,如QSC6085/QSC1110平台;双工器主要用于CDMA/WCDMA平台,QCT/ST-E/VIA/MTK都有用到。
点评回复

使用道具 举报

 楼主| 发表于 2010-10-30 20:21:20 | 显示全部楼层
晕,有人能告诉我怎么传图片吗?我上传.jpg的附件怎么看不到?
再上个doc的试试。
【文件名】:101030@52RD_原理图.doc
【格 式】:doc
【大 小】:134K
【简 介】:
【目 录】:
点评回复

使用道具 举报

 楼主| 发表于 2010-10-30 20:16:13 | 显示全部楼层
图片怎么出不来,再来一次。
点评回复

使用道具 举报

发表于 2013-12-27 16:33:00 | 显示全部楼层
直白说,duplexer是区分TX和RX的, diplexer是区分high frequency 和 low frequency
点评回复

使用道具 举报

发表于 2014-2-25 15:04:53 | 显示全部楼层
相当直白 明白了 谢谢
点评回复

使用道具 举报

发表于 2014-3-24 17:09:16 | 显示全部楼层
学习了。。。。
点评回复

使用道具 举报

发表于 2014-11-5 10:53:14 | 显示全部楼层
這下終於明白啦,tks~
点评回复

使用道具 举报

发表于 2014-11-10 10:57:16 | 显示全部楼层
最大区别, DIPLEXER是功分器加两个滤波器的组合, DUPLEXER是环形器加连个滤波器的组合
点评回复

使用道具 举报

发表于 2014-11-24 20:20:18 | 显示全部楼层
暂时还没用过 这些器件
点评回复

使用道具 举报

发表于 2014-12-4 15:15:34 | 显示全部楼层
lawrencewu 发表于 2010-10-31 21:39
diplexer 的定义,第一段已经说的比较清楚了,中文叫分频器,内部由一个高通滤波器和一个低通滤波器构成, ...

原来这样啊
点评回复

使用道具 举报

发表于 2014-12-15 22:53:43 | 显示全部楼层
大概懂了个80%,应用起来可能还不顺手
http://blog.sina.com.cn/s/blog_67b957eb0100rrrx.html这个微博分享的最后那个diplexer当做duplexer用的图也看不了啦
点评回复

使用道具 举报

发表于 2015-9-18 16:23:33 | 显示全部楼层
学习了

点评回复

使用道具 举报

发表于 2017-2-23 11:21:59 | 显示全部楼层
谢谢分享
点评回复

使用道具 举报

发表于 2017-10-16 11:44:41 | 显示全部楼层
diplexer 是双信器,duplexer是双工器
点评回复

使用道具 举报

高级模式
B Color Image Link Quote Code Smilies

本版积分规则

Archiver|手机版|小黑屋|52RD我爱研发网 ( 沪ICP备2022007804号-2 )

GMT+8, 2024-4-19 10:58 , Processed in 0.053403 second(s), 17 queries , Gzip On.

Powered by Discuz! X3.5

© 2001-2023 Discuz! Team.

快速回复 返回顶部 返回列表