找回密码
 注册
搜索
查看: 661|回复: 2

[综合资料] 13个ADS实验集(英文)

[复制链接]
发表于 2008-12-18 21:41:04 | 显示全部楼层 |阅读模式
为了换取一些积分,不好意思收取一些费用了!
【文件名】:081218@52RD_ADS实验集.pdf
【格 式】:pdf
【大 小】:3422K
【简 介】:13个ADS的经典实验例子,很适合初学者!
【目 录】:Lab 1: Basics of using ADS
OBJECTIVES
• Examine the Main window commands and icons
• Create a new project and schematic design
• Setup and perform an S-parameter simulation
• Display the simulation data on a plot and save files
• Tune the circuit to refine the response
• Look through the Examples and do a Harmonic Balance simulation
Lab 2: DC Simulations
OBJECTIVES
• Build a symbolized sub-circuit for use in the hierarchy
• Create a family of curves for the device used in the mixer
• Sweep variables, pass parameters, and the plot or list the data
• Use equations to calculate bias resistor values from simulation data
NOTE about this lab: This lab and the remaining labs will use the BJT mixer to demonstrate all
types of simulations. Regardless of the type of circuit you design, the techniques and
simulations presented in these labs will be applicable to many other circuit configurations.
The DC Simulation controller, calculates the DC operating characteristics of a design under test
(DUT). Fundamental to all RF/Analog simulations, DC analysis is used on all RF/Analog designs. It
performs a topology check and an analysis of the DC operating point, including the circuit's power
consumption. The simulator computes the response of a circuit to a particular stimulus by formulating
a system of circuit equations and then solving them numerically. The DC simulation accomplishes this
analysis as follows:
• Solves a system of nonlinear ordinary differential equations (ODEs)
• Solves for an equilibrium point
• All time-derivatives are constant (zero)
• System of nonlinear algebraic equations
Lab 3: AC Simulations
OBJECTIVES
• Perform AC small-signal and noise simulations
• Sweep variables, tune parameters, write equations
• Control plots, traces, datasets, and AC sources
About this lab: This lab continues the mixer project and uses the same sub-circuit as the
previous lab.
Lab 4: S-parameter Simulations
OBJECTIVES。。。
[UseMoney=3]

[/UseMoney]
发表于 2010-5-13 16:44:22 | 显示全部楼层
好东西,谢谢分享!
点评回复

使用道具 举报

发表于 2010-5-13 16:59:00 | 显示全部楼层
谢谢分享!
点评回复

使用道具 举报

高级模式
B Color Image Link Quote Code Smilies

本版积分规则

Archiver|手机版|小黑屋|52RD我爱研发网 ( 沪ICP备2022007804号-2 )

GMT+8, 2024-11-18 23:31 , Processed in 0.053040 second(s), 19 queries , Gzip On.

Powered by Discuz! X3.5

© 2001-2023 Discuz! Team.

快速回复 返回顶部 返回列表