This document describes the architecture of the calibration program running at calibration controller. The document is intended for handset calibration/test software designers.
1 Introduction..................
2 Associated Documents..
3 Main architecture
3.1 Hardware requirement
3.2 Files list
3.3 Handset communication interface
3.4 GSM tester communication interface
3.5 MMI interface....
3.5.1 Architecture.
3.5.2 Starting the application
3.5.3 Main Window
3.5.4 Setup Phone Dialog
3.5.5 Add/Delete Version Dialog
3.5.6 Edit Parameters Dialog
3.5.7 System parameter setting
4 Calibration procedure in details...........
4.1 Procedure of calibrating 13MHZ VCO control signal voltage DAC value and slope value
4.2 Procedure of calibrating received signal compensation table......
4.3 Calibrating power amplifier(PA) ramp profile for each Tx level and band procedure
4.4 Calibrating RX signal level compensation for each frequency procedure
以下是引用joyman在2006-3-17 14:21:00的发言：
This document describes the architecture of the calibration program running at calibration controller. The document is intended for handset calibration/test software designers.
1 Introduction..................
2 Associated Documents..
3 Main architecture
3.1 Hardware requirement
3.2 Files list
3.3 Handset communication interface
3.4 GSM tester communication interface
3.5 MMI interface....
3.5.1 Architecture.
3.5.2 Starting the application
3.5.3 Main Window
3.5.4 Setup Phone Dialog
3.5.5 Add/Delete Version Dialog
3.5.6 Edit Parameters Dialog
3.5.7 System parameter setting
4 Calibration procedure in details...........
4.1 Procedure of calibrating 13MHZ VCO control signal voltage DAC value and slope value
4.2 Procedure of calibrating received signal compensation table......
4.3 Calibrating power amplifier(PA) ramp profile for each Tx level and band procedure
4.4 Calibrating RX signal level compensation for each frequency procedure
IP卡
狗仔卡
发表于 2006-3-17 14:21:00
提升卡
置顶卡
沉默卡
喧嚣卡
变色卡
显身卡