Fast Device Tune ImplementatiFast Device Tune Implementation
§ Step 1: Preset Test Set
§ Step 2: Set Path Loss
§ Step 3: Set Initial Condition
§ Step 4: Set MS Rx series
§ Step 5: Set MS Tx series
§ Step 6: Check MS config
§ Step 7: FDT Measure
§What is ARM ?
It is signal that “I’m ready for measurement!”
8960 will return 1 for I’m ready. If it isn’t ready for measurement, you
need to wait a little bit, if it says 0, you have some problem on set-up.
If you got 0, check the parameters first.
For example if Tx Step frequency is not in the single band range, it will
return 0, if triggered already it will return 0.